Wheelchair manufacturers say foot pedal installation and adjustment
Update:31-12-2021
Summary:If the seat of the electric wheelchair is too high or the pedal is too low, it will cause the lower limbs to lose support, the lower limbs are suspend...
If the seat of the electric wheelchair is too high or the pedal is too low, it will cause the lower limbs to lose support, the lower limbs are suspended, and the body cannot maintain balance. Conversely, when the seat is too high, the wheelchair armrest cannot be pushed under the table; the entire weight makes the patient feel uncomfortable. The following is a brief introduction to the installation and adjustment of the electric wheelchair pedal by the wheelchair manufacturer.
The height of the seat is coordinated with the height of the pedals: if the seat is higher, the pedals are relatively low, and vice versa. Under normal circumstances, when the patient is sitting in a wheelchair with the lower limbs on the footstool, the distance from the heel to the rouge socket increases by 4cm, or the front 1/3 of the thighs and calves are about 4cm higher than the footstool. The edge of the front pad. This is a wheelchair. Expected seat height. The surface of the pedal should be at least 5cm from the ground.
Pedal disassembly: Loosen and remove the nut at the junction of the foot and the frame tube, and then pull out the pedal assembly.
Foot pedal installation: Put the original pedal into the frame tube, push it into place, and then tighten the screws.
Adjust the height of the pedal: use the wrench in the product kit to loosen the screw and nut, adjust the height according to the length of the user's foot, and tighten the screw. Please note that the end of the screw must be on the inside and locked from the inside to the outside.
https://www.shenyumedical.com/
